Product details

DM-G8518

Motors & Drives

Shenzhen Damao Technology Co., Ltd.

DM-G8518

About this product

DM-G8518 is a DAMIAO hollow-shaft gimbal motor for motion-control integration. Its hollow center supports cable routing, and the motor and drive are integrated. The published 24 V and 48 V supply-current and speed values are retained separately. Peak duration and duty cycle are not specified. An exact release date is not verified.

Model
DM-G8518
Category
Motors & Drives, Components

Specifications & evidence

Source-backed claims. Configuration, workload and evidence type matter when comparing products.

Can communication-loss protection

Exit enabled mode if no CAN command arrives within the configured interval

Manufacturer specification

Configuration: DM-G8518; The timeout is configurable; no numerical default is stated.

DM-G8518 official table, visually transcribed
设定周期内没有收到CAN指令将自动退出“使能模式”

Can feedback

Motor speed, position, torque and temperature

Manufacturer specification

Configuration: DM-G8518; Manufacturer exact-product feature statement.

DM-G8518_云台_产品中心_深圳市达妙科技有限公司
可通过CAN总线反馈电机速度、位置、转矩、电机温度等信息。

Central through-hole diameter

33 mm

Manufacturer specification

Configuration: DM-G8518; Manufacturer specification for this model; additional measurement conditions are not stated.

DM-G8518 official table, visually transcribed
中孔尺寸 33mm

Control interface (published base table)

CAN@5Mbps(Max)

Manufacturer specification

Configuration: DM-G8518; Published base specification table.

DM-G8518 official table, visually transcribed
控制接口 CAN@5Mbps(Max)

Control modes

MIT; position-speed; speed; hybrid force-position

Manufacturer specification

Configuration: DM-G8518; Control-mode names translated from the official table.

DM-G8518 official table, visually transcribed
控制模式 MIT模式 位置速度模式 速度模式 力位混控模式

Drive overtemperature threshold

120 degC

Manufacturer specification

Configuration: DM-G8518; Protection threshold; drive overheating exits enabled mode. This is not an ambient temperature rating.

DM-G8518 official table, visually transcribed
防护温度:120°C

Encoder accuracy

0.03 deg

Manufacturer specification

Configuration: DM-G8518; Symmetric plus/minus accuracy, as published.

DM-G8518 official table, visually transcribed
编码器精度 ±0.03°

Encoder count

1

Manufacturer specification

Configuration: DM-G8518; Manufacturer specification for this model; additional measurement conditions are not stated.

DM-G8518 official table, visually transcribed
编码器个数 1

Encoder resolution

17 bit

Manufacturer specification

Configuration: DM-G8518; Published encoder resolution; separate accuracy retained.

DM-G8518 official table, visually transcribed
编码器位数 17位

Encoder type

Single encoder, single-turn

Manufacturer specification

Configuration: DM-G8518; Manufacturer specification for this model; additional measurement conditions are not stated.

DM-G8518 official table, visually transcribed
编码器类型 单编(单圈)

Height

52.5 mm

Manufacturer specification

Configuration: DM-G8518; Manufacturer table dimension.

DM-G8518 official table, visually transcribed
高度 52.5mm

Hollow motor structure

Hollow structure for cable routing

Manufacturer specification

Configuration: DM-G8518; Manufacturer exact-product feature statement.

DM-G8518_云台_产品中心_深圳市达妙科技有限公司
电机结构为中空设计,方便走线,轻化机身。

Integrated drive

Motor and drive integrated

Manufacturer specification

Configuration: DM-G8518; Manufacturer exact-product feature statement.

DM-G8518_云台_产品中心_深圳市达妙科技有限公司
电机和驱动器一体化设计,结构紧凑,集成度高。

Maximum supported supply voltage

48 V

Manufacturer specification

Configuration: DM-G8518; supply range; Published supported supply range.

DM-G8518 official table, visually transcribed
额定电压 24V(支持24-48V)

Minimum supported supply voltage

24 V

Manufacturer specification

Configuration: DM-G8518; supply range; Published supported supply range.

DM-G8518 official table, visually transcribed
额定电压 24V(支持24-48V)

Motor mass

831 g

Manufacturer specification

Configuration: DM-G8518; Approximate manufacturer motor mass; not asserted to include a separate drive.

DM-G8518 official table, visually transcribed
电机重量 约831g

Outside diameter

96 mm

Manufacturer specification

Configuration: DM-G8518; Manufacturer table dimension.

DM-G8518 official table, visually transcribed
外径 96mm

Parameter-tuning interface

UART@921600bps

Manufacturer specification

Configuration: DM-G8518; Manufacturer specification for this model; additional measurement conditions are not stated.

DM-G8518 official table, visually transcribed
调参接口 UART@921600bps

Peak phase current

36.1 A

Manufacturer specification

Configuration: DM-G8518; 24 V configuration; Peak value; permitted duration and duty cycle are not stated.

DM-G8518 official table, visually transcribed
峰值相/电源电流 36.1A/33.05A@24V | 36.1A/18.05A@48V

Peak phase current

36.1 A

Manufacturer specification

Configuration: DM-G8518; 48 V configuration; Peak value; permitted duration and duty cycle are not stated.

DM-G8518 official table, visually transcribed
峰值相/电源电流 36.1A/33.05A@24V | 36.1A/18.05A@48V

Peak speed

1,290 rpm

Manufacturer specification

Configuration: DM-G8518; 24 V configuration; Peak value; duration and duty cycle are not stated.

DM-G8518 official table, visually transcribed
峰值转速 1290rpm@24V | 2590rpm@48V

Peak speed

2,590 rpm

Manufacturer specification

Configuration: DM-G8518; 48 V configuration; Peak value; duration and duty cycle are not stated.

DM-G8518 official table, visually transcribed
峰值转速 1290rpm@24V | 2590rpm@48V

Peak supply current

33.05 A

Manufacturer specification

Configuration: DM-G8518; 24 V configuration; Peak value; permitted duration and duty cycle are not stated.

DM-G8518 official table, visually transcribed
峰值相/电源电流 36.1A/33.05A@24V | 36.1A/18.05A@48V

Peak supply current

18.05 A

Manufacturer specification

Configuration: DM-G8518; 48 V configuration; Peak value; permitted duration and duty cycle are not stated.

DM-G8518 official table, visually transcribed
峰值相/电源电流 36.1A/33.05A@24V | 36.1A/18.05A@48V

Peak torque

8.78 N m

Manufacturer specification

Configuration: DM-G8518; Peak value; duration and duty cycle are not stated.

DM-G8518 official table, visually transcribed
峰值扭矩 8.78Nm

Phase inductance

105 uH

Manufacturer specification

Configuration: DM-G8518; At 25 degrees C; measurement method is not stated.

DM-G8518 official table, visually transcribed
相电感 105uH(@25°C)

Phase resistance

0.225 ohm

Manufacturer specification

Configuration: DM-G8518; At 25 degrees C; measurement method is not stated.

DM-G8518 official table, visually transcribed
相电阻 0.225Ω(@25°C)

Pole pairs

16

Manufacturer specification

Configuration: DM-G8518; Manufacturer specification for this model; additional measurement conditions are not stated.

DM-G8518 official table, visually transcribed
极对数 16

Rated phase current

9.55 A

Manufacturer specification

Configuration: DM-G8518; 24 V configuration; Rated value; thermal and duty conditions are not stated.

DM-G8518 official table, visually transcribed
额定相/电源电流 9.55A/10.51A@24V | 9.55A/10.05A@48V

Rated phase current

9.55 A

Manufacturer specification

Configuration: DM-G8518; 48 V configuration; Rated value; thermal and duty conditions are not stated.

DM-G8518 official table, visually transcribed
额定相/电源电流 9.55A/10.51A@24V | 9.55A/10.05A@48V

Rated speed

1,000 rpm

Manufacturer specification

Configuration: DM-G8518; 24 V configuration; Rated manufacturer value; test setup and thermal conditions are not stated.

DM-G8518 official table, visually transcribed
额定转速 1000rpm@24V | 2000rpm@48V

Rated speed

2,000 rpm

Manufacturer specification

Configuration: DM-G8518; 48 V configuration; Rated manufacturer value; test setup and thermal conditions are not stated.

DM-G8518 official table, visually transcribed
额定转速 1000rpm@24V | 2000rpm@48V

Rated supply current

10.51 A

Manufacturer specification

Configuration: DM-G8518; 24 V configuration; Rated value; thermal and duty conditions are not stated.

DM-G8518 official table, visually transcribed
额定相/电源电流 9.55A/10.51A@24V | 9.55A/10.05A@48V

Rated supply current

10.05 A

Manufacturer specification

Configuration: DM-G8518; 48 V configuration; Rated value; thermal and duty conditions are not stated.

DM-G8518 official table, visually transcribed
额定相/电源电流 9.55A/10.51A@24V | 9.55A/10.05A@48V

Rated torque

1.9 N m

Manufacturer specification

Configuration: DM-G8518; Rated manufacturer value; test setup and thermal conditions are not stated.

DM-G8518 official table, visually transcribed
额定扭矩 1.9Nm

Rated voltage

24 V

Manufacturer specification

Configuration: DM-G8518; Nominal rated voltage. The manufacturer also supports the stated supply range.

DM-G8518 official table, visually transcribed
额定电压 24V(支持24-48V)

Rear-cover mounting limitation

Do not use the rear-cover threaded holes to connect load-bearing structural parts

Manufacturer specification

Configuration: DM-G8518; Manufacturer drawing warning: using these rear-cover holes for load-bearing connections can damage the rear-cover structure.

DM-G8518 official table, visually transcribed
不建议使用后盖螺纹孔用作承载结构件的连接 易造成后盖结构损坏

Recommended maximum motor-temperature setting

100 degC

Manufacturer specification

Configuration: DM-G8518; User-configurable motor-temperature protection setting; manufacturer recommends no more than 100 degrees C. Exits enabled mode on overheating.

DM-G8518 official table, visually transcribed
建议不超过100°C

Recommended maximum overcurrent setting

0.98 (unit not specified)

Manufacturer specification

Configuration: DM-G8518; Configurable protection setting; exits enabled mode on overcurrent. The printed 0.98 has no defined unit and is not interpreted as amperes or a normalized percentage.

DM-G8518 official table, visually transcribed
建议不超过0.98

Recommended maximum overvoltage setting

54 V

Manufacturer specification

Configuration: DM-G8518; Configurable protection recommendation; not normal operating voltage.

DM-G8518 official table, visually transcribed
建议不超过54V

Recommended minimum supply voltage in undervoltage instructions

20 V

Manufacturer specification

Configuration: DM-G8518; Undervoltage-protection instruction; configurable trip threshold not stated.

DM-G8518 official table, visually transcribed
电源电压不低于20V

Slot count (manufacturer table)

36

Manufacturer specification

Configuration: DM-G8518; The source row is literally labeled slot/pole count; the separate pole-pair row is retained independently.

DM-G8518 official table, visually transcribed
槽极数 36

Related products

Contact Us

If you have any questions or would like to get in touch, please feel free to reach out to us at the email below.

info@robotuo.com

YOUR CHOICES

Privacy settings

Choose each optional purpose. All are off until you agree. Change or withdraw consent at any time; browsing still works if you reject all.

Privacy preference

Remembers the choice you make here.

Always active

Save comparisons and followed companies and products between visits. Turning this off deletes saved selections; you can still use them during this visit.

Allow Google Analytics through Firebase to measure general page visits and usage with cookies and device information. Advertising remains off.

Allow OneSignal to process browser and subscription information for Robotuo news and updates. Browser permission is a separate step.

Your shortlist

0 companies selectedUp to 10

Your shortlist is empty. Browse companies and add the ones you’d like to connect with.